User Tools

Site Tools


adding_shutter_to_filter_wheel

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
adding_shutter_to_filter_wheel [2019/05/22 19:02]
dave [Part 1: Adding a Normally Closed Shutter.]
adding_shutter_to_filter_wheel [2019/05/22 19:03] (current)
dave [Part 1: Adding a Normally Closed Shutter.]
Line 10: Line 10:
  
 **NOTE:​** ​ ASI no longer supports mechanical shutters. ​  The FW-1000s shown in this document are older units. ​  Newer FW-1000 housings may no longer have the cut outs to support having shutters installed in them. **NOTE:​** ​ ASI no longer supports mechanical shutters. ​  The FW-1000s shown in this document are older units. ​  Newer FW-1000 housings may no longer have the cut outs to support having shutters installed in them.
 +
 +
 Step 1: On a clean work table lay out the filter wheel, tools and the shutter to be installed. Remove the nine flat head #4 screws from the outer edge of the motor side of the filter wheel. Remove the back cover from the filter wheel. The cover has tight clearance around the motor housing and must be removed as seen in figure 3.  Step 1: On a clean work table lay out the filter wheel, tools and the shutter to be installed. Remove the nine flat head #4 screws from the outer edge of the motor side of the filter wheel. Remove the back cover from the filter wheel. The cover has tight clearance around the motor housing and must be removed as seen in figure 3. 
  
adding_shutter_to_filter_wheel.txt · Last modified: 2019/05/22 19:03 by dave