User Tools

Site Tools


commands:aij

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
commands:aij [2016/09/07 22:03]
asiadmin ↷ Page moved from documentation:commands:aij to commands:aij
commands:aij [2019/04/18 23:32] (current)
Line 1: Line 1:
 +====== Command:AIJ ======
  
 +--> Array Module#
 +
 +--> MS2000 or RM2000 syntax#
 +
 +^Shortcut ​ |IJ   ​| ​
 +^Format ​ |AIJ [X=i] [Y=j] |
 +^Units ​   |array location|
 +^Required Firmware Module ​   |ARRAY|
 +^Remembered |Using SS Z |
 +
 +<--
 +
 +--> Tiger syntax# ​
 +
 +^Shortcut ​ |IJ   ​| ​
 +^Format ​ |[addr#]AIJ [X=i] [Y=j] |
 +^Units ​   |array location|
 +^Type    |Card-Addressed ​ |
 +^Required Firmware Module ​   |ARRAY|
 +^Remembered |Using [addr#]SS Z |
 +
 +<--
 +
 +Used with the ''​ARRAY''​ command to move to array location (i,j), where i and j are the indices of the desired array location. ​ The ''​AHOME''​ location is position (1,​1).  ​
 +
 +<--
 +
 +
 +--> Tiger MicroMirror Phototargeting#​
 +
 +^Shortcut ​ |IJ   ​| ​
 +^Format ​ |[addr#]AIJ [X=horiz_position] [Y=vert_position] ​ |
 +^Units ​   |axis units|
 +^Type    |Card-Addressed ​ |
 +^Required Firmware Module ​   |MM_TARGET |
 +^Remembered |Using [addr#]SS Z |
 +
 +Moves to the specified location ''​(horiz_position,​ vert_position)''​ subsequently pulses the laser TTL signal. ​ Positions are specified in axis units (the same as used by the [[commands:​where|WHERE]] or [[commands:​move|MOVE]] command). ​ If the X and/or Y argument is omitted, the corresponding position from the last AIJ command will be used.  Note that the position is changed as a side effect of this command. ​ The [[commands:​where|WHERE]] or [[commands:​move|MOVE]] command will change the beam position without pulsing the laser TTL signal.
 +
 +The settling delay before turning on the laser and the laser pulse high time are specified using the [[commands:​wait|WAIT]] and [[commands:​rtime|RTIME commands]] respectively.
 +
 +The assignments of horizontal and vertical axes are done using the [[commands:​scan|SCAN command]] (most users will never need to change the defaults: the horizontal or X axis is the card’s first axis and the vertical or Y axis is the card’s second axis).
 +
 +
 +
 +
 +<--
 +
 +
 +
 +
 +{{tag>​commands tiger ms2000 array Phototargeting}}
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/aij.txt · Last modified: 2019/04/18 23:32 (external edit)