|Format||JSSPD [X=high] [Y=low] [Z=knob_speed] [F=xy_knobs_high] [T=xy_knobs_low]|
|Remembered||Using SS Z|
|Format||[Addr#]JSSPD [X=high] [Y=low] [Z=knob_speed] [F=xy_knobs_high] [T=xy_knobs_low]|
|Remembered||Using [addr#]SS Z|
This command sets the relative motor speed for maximum deflection of the joystick to the values specified. Values between 0.1 and 100 (%) are acceptable, or -100 to -0.1 (negative setting reverses the direction). Pressing the Joystick button toggles between the
Knob_speed is a signed value that sets the relative speed and direction of the encoder knob (not commonly used on TG-1000).
xy_knobs_low are used to set the fast and slow speeds for XY_KNOBS and ZF_KNOB, which respond to input from the two knobs on the side of the TG-1000 joystick. Note this is different from MS-2000 where the F parameter set the low speed and the high speed was given by the low speed multiplied by the T parameter raised to the third power. Note that prior to stage firmware version 2.87 the implementation for F and T was like MS-2000.
If there are no errors, the positive reply :A will be sent back from the controller.
1JS X? Y? :A X=80.000000 Y=3.000000
JS X? Y? :A JS_FAST=100 JS_SLOW=5