User Tools

Site Tools


commands:jsspd

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
commands:jsspd [2019/04/18 23:33]
127.0.0.1 external edit
commands:jsspd [2020/01/19 22:30] (current)
melissa
Line 4: Line 4:
  
 ^Shortcut ​ |JS|  ^Shortcut ​ |JS| 
-^Format ​ |JSSPD [X=high] [Y=low] [Z=knob_speed] [F=xy_knobs_high] [T=xy_knobs_low] |+^Format ​ |JSSPD [X=fast] [Y=slow] [Z=knob_speed] [F=xy_knobs_fast] [T=xy_knobs_slow] |
 ^Units ​   |integer| ^Units ​   |integer|
 ^Remembered |Using SS Z | ^Remembered |Using SS Z |
Line 13: Line 13:
  
 ^Shortcut ​ |JS|  ^Shortcut ​ |JS| 
-^Format ​ |[Addr#​]JSSPD [X=high] [Y=low] [Z=knob_speed] [F=xy_knobs_high] [T=xy_knobs_low] |+^Format ​ |[Addr#​]JSSPD [X=fast] [Y=slow] [Z=knob_speed] [F=xy_knobs_fast] [T=xy_knobs_slow] |
 ^Units ​   |integer| ^Units ​   |integer|
 ^Type    |Card-Addressed| ^Type    |Card-Addressed|
Line 24: Line 24:
 ''​Knob_speed''​ is a signed value that sets the relative speed and direction of the encoder knob (not commonly used on TG-1000). ''​Knob_speed''​ is a signed value that sets the relative speed and direction of the encoder knob (not commonly used on TG-1000).
  
-''​xy_knobs_high''​ and ''​xy_knobs_low''​ are used to set the fast and slow speeds for  XY_KNOBS and ZF_KNOB, which respond to input from the two  knobs on the side of the TG-1000 joystick. ​ Note this is different from MS-2000 where the F parameter ​set the low speed and the high speed was given by the low speed multiplied by the T parameter raised to the third power. ​ Note that prior to stage firmware version 2.87 the implementation for F and T was like MS-2000.+''​xy_knobs_high''​ and ''​xy_knobs_low''​ are used to set the fast and slow speeds for XY_KNOBS and ZF_KNOB, which respond to input from the two  knobs on the side of the TG-1000 joystick. ​ Note this is different from MS-2000 where the F parameter ​sets the slow speed and the fast speed is equal to the low speed multiplied by the T parameter raised to the third power. ​ Note that prior to stage firmware version 2.87 the implementation for F and T was like MS-2000.
  
 If there are no errors, the positive reply <wrap reply> :A </​wrap>​ will be sent back from the controller. If there are no errors, the positive reply <wrap reply> :A </​wrap>​ will be sent back from the controller.
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/jsspd.1555630387.txt.gz · Last modified: 2019/04/18 23:33 by 127.0.0.1