User Tools

Site Tools


commands:pcros

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
commands:pcros [2018/03/13 23:06]
vik
commands:pcros [2019/04/18 23:33] (current)
Line 1: Line 1:
 +====== Command:​PCROS (PC) ======
 +-->​Motorized Axis#
 +--> MS2000 or RM2000 syntax#
  
 +^Shortcut ​ |PC   ​| ​
 +^Format ​ |PCROS [Axis]= [units mm]… |
 +^Units ​   |millimeter|
 +^Remembered |Using SS Z |
 +
 +<--
 +
 +--> Tiger syntax# ​
 +
 +^Shortcut ​ |PC   ​| ​
 +^Format ​ |PCROS [Axis]= [units mm]… |
 +^Units ​   |millimeter|
 +^Type    |Axis-Specific ​ |
 +^Remembered |Using [addr#]SS Z |
 +
 +<--
 +
 +This command sets/​displays the Finish Error setting, which controls when the motor algorithm routines will turn off.  The setting controls the crossover position error (in millimeters) between the target and position at which the MFC 2000 and TG-1000 AND MS 2000  controller will stop attempting to move the stage closer to achieving the position=target. ​ This is value also determines the maximum error allowable before a move is considered complete. ​ This value is usually set to the value of the smallest move step size according to the encoder resolution. ​ The current value for this setting can be viewed using the ''​INFO''​ command. ​
 +
 +== Example ==
 +
 +<asi> $ PC X=.00005 Y=.00002 Z=.00005 ​
 +:​A</​asi>​
 +
 +Values equal to or less than zero are acknowledged by <wrap reply> :A </​wrap>,​ but ignored.
 +
 +The command in this example will make the controller consider a ''​MOVE''​ command complete when the difference between the target and the current position is 50 nm for X, 20 nm for Y, and 50 nm for Z.  ​
 +
 +<WRAP center round important 60%>
 +Warning: ​ If the ''​PCROS''​ value is extremely small, moves may take an excessively long time to complete.
 +</​WRAP>​
 +
 +<--
 +
 +--> Tunable Lens#
 +
 +
 +^Shortcut ​ |PC   ​| ​
 +^Format ​ |PCROS [Axis]= ###… |
 +^Units ​   |float|
 +^Type    |Axis-Specific ​ |
 +^Remembered |Automatically |
 +
 +On the Tunable Lens card this command gets and sets a different parameter. Tunable lens diopter changes with temperature , this change varies with current being applied to the lens. So we built a model equation to help us calculate this Diopter per Celsius change. PC command sets the constant in this model equation. [[:​tiger_tunable_lens_card#​temperature_compensation|More info here]] ​
 +
 +<--
 +
 +
 +
 +
 +{{tag>​commands tiger ms2000 tlens}}
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/pcros.txt · Last modified: 2019/04/18 23:33 (external edit)