User Tools

Site Tools


You are not allowed to perform this action
commands:pr

Command:PR

This is a Tiger only command , that has different usage for MicroMirrors and Piezos

MicroMirror
Shortcut PR
Format PR [axis]=[5 to 10] …
Units Integer code, 5 to 10
Type Axis-Specific
Remembered Automatically
Firmware Requiredv2.83+

This command is “recycled” for a different use in MicroMirror axes than for piezo. In the context of a MicroMirror axis this command is used to set the MicroMirror travel range. Settings is automatically saved into non-voltatile memory, however controller needs a system RESET or RESTART for setting to take effect.

PR[Axis Name] = MicroMirror Range
in degrees
5 5
6 6
8
(default)
8
10 10

Example

PR A=5		
:A

Sets range of A axis as 5 degrees

PR A? B?			
A=5 B=8 :A

Queries the range of axes

Piezo
Shortcut PR
Format PR [axis]=[0 to 8] …
Units Integer code, 0 to 8
Type Axis-Specific
Remembered Automatically

PR is used to set the piezo travel range. It is an Axis specific command. Setting is automatically saved in the non-volatile memory. Will need a system RESET or RESTART for setting to take effect.

PR [Axis Name] = Piezo Range
in microns
1 50
2 100
3 150
4 200
5 300
6 350
7 500
8 70
Tunable Lens
Shortcut PR
Format PR [axis]=[0 to 3] …
Units Integer code, 0 to 3
Type Axis-Specific
Remembered Automatically

PR is used to set the Tunable Lens units or user input. It is an Axis specific command. Setting is automatically saved in the non-volatile memory. Will need a system RESET or RESTART for setting to take effect. For more info refer to Units/Resolution section on TGTLC card page.

PR [Axis Name] = Units
1 (default) 16bit integer, +32768 to -32768
2 1/1000 of dpt, range usually between 26000 to 7000
3 TBD reserved for future use
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/pr.txt · Last modified: 2019/04/18 23:33 (external edit)