User Tools

Site Tools


commands:sam

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
commands:sam [2019/04/18 23:33]
127.0.0.1 external edit
commands:sam [2019/09/10 23:35] (current)
vik
Line 25: Line 25:
 |0 |Puts single-axis mode in idle state (i.e. stops it if running) ​                                                             | |0 |Puts single-axis mode in idle state (i.e. stops it if running) ​                                                             |
 |1 |Puts the single-axis mode in active state (i.e. starts generating the pattern) ​                                             | |1 |Puts the single-axis mode in active state (i.e. starts generating the pattern) ​                                             |
-|2 |Arms the trigger; on receipt of a TTL trigger pulse the single-axis mode becomes active ​                                    |+|2 |Arms the trigger; on receipt of a TTL trigger pulse the single-axis mode becomes active. Pre Tiger version 3.31 after the TTL routine the pattern was free running. Post 3.31, the routine only cycles once, then waits again for another TTL trigger. ​                                    |
 |3 |Makes the single-axis mode active and restarts the pattern of any other axis on the same card so they will be synchronized ​ | |3 |Makes the single-axis mode active and restarts the pattern of any other axis on the same card so they will be synchronized ​ |
  
Line 38: Line 38:
 <asi> $ SAM B=2  ​ <asi> $ SAM B=2  ​
 :​A</​asi>​ :​A</​asi>​
-Arms the routine for the B axis. The routine for B will start running on receipt of a TTL pulse +Arms the routine for the B axis. The routine for B will start running on receipt of a TTL pulse. Pre Tiger version 3.31 after the TTL trigger the routine was free running. Post 3.31, the routine only cycles once, then waits again for another TTL trigger. ​  
 + 
 +Works with [[commands:​ttl|TTL X=30]] mode. 
 <asi> $ SAM B=3  ​ <asi> $ SAM B=3  ​
 :​A</​asi>​ :​A</​asi>​
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/sam.txt · Last modified: 2019/09/10 23:35 by vik