User Tools

Site Tools


commands:setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
commands:setup [2016/09/07 22:04]
asiadmin ↷ Links adapted because of a move operation
commands:setup [2019/04/18 23:33] (current)
Line 1: Line 1:
 +====== Command:​SETUP (SU) ======
  
 +--> MS2000 or RM2000 syntax#
 +
 +^Shortcut ​ |SU| 
 +^Format ​ |SU [axis]=[position in mm]…|
 +^Units ​   |millimeter|
 +^Remembered |Using SS Z |
 +
 +<--
 +
 +--> Tiger syntax# ​
 +
 +^Shortcut ​ |SU| 
 +^Format ​ |SU [axis]=[position in mm]…|
 +^Units ​   |millimeter|
 +^Type    |Axis-Specific ​ |
 +^Remembered |Using [addr#]SS Z |
 +
 +<--
 +
 +Same as [[commands:​setlow|SETLOW command]] (see above) but for upper firmware limit switch
 +
 +**Note 1:**  If this value is equal to or less than the value for ''​SETLOW'',​ then the controller will operate incorrectly. See also Note 2.\\
 +**Note 2:** When the direction of an axis is negative (see [[commands:​customa|CCA Z=###]]), upper limit settings must be negative values, and lower limit settings must be positive values. \\
 +**Note 3:**  For clocked devices (e.g. filter sliders, turrets) the upper limit is always the number of positions. ​ Querying the value is useful for determining how many positions. \\
 +**Note 4:**  As of Tiger firmware v2.8, ''​SU [axis]+''​ will set the upper limit to be the current position. ​ Restore the default limit by executing''​ SU [axis]-''​. \\
 +
 +
 +{{tag>​commands tiger ms2000}}
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
commands/setup.txt · Last modified: 2019/04/18 23:33 (external edit)