User Tools

Site Tools


conix_ms4_zdrive

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

conix_ms4_zdrive [2016/10/04 22:13]
conix_ms4_zdrive [2019/04/18 23:34] (current)
Line 1: Line 1:
 +====== Conix MS-4 Z-Axis Drive Installation ======
  
 +
 +The open loop belt drive attaches to the coarse focus knob via the thumbscrews as shown in the photos below. ​ The fine focus knob pulley is attached to the fine focus knob as shown via the setscrews located on the fine focus knob pulley. ​ The belt is stretched between the two pulleys as shown and once in place the cover is installed. ​ The drive is connected to the controller via the connector on the rear of the drive.
 +
 +[{{ conix_1.jpg?​direct&​300 |Click to Enlarge}}]
 +
 +[{{ conix_2.jpg?​direct&​300 |Click to Enlarge}}]
 + ​  ​
 +[{{ conix_3.jpg?​direct&​300 |Click to Enlarge}}]
 + 
 +{{tag>​conix zdrive others}}