User Tools

Site Tools


ftp_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
ftp_setup [2019/04/18 23:34]
127.0.0.1 external edit
ftp_setup [2019/07/08 14:58] (current)
jon [Mount XY Stage] added note to check for proud screws
Line 24: Line 24:
 2. Measure the distance between the X- and X+ mounting holes in the XY stage’s bottom plate, as in Figure 1. (Use the joystick or a serial command to move the X-axis to either side to reveal the mounting holes.) ​ 2. Measure the distance between the X- and X+ mounting holes in the XY stage’s bottom plate, as in Figure 1. (Use the joystick or a serial command to move the X-axis to either side to reveal the mounting holes.) ​
  
-[{{ :​ftp-measure.png?​200 |//Figure 1: the distance between mounting holes//}}]+[{{ :​ftp-measure.png?​300 |//Figure 1: the distance between mounting holes//}}]
  
 3. Space the stilts on the breadboard so that the stage will mount 3. Space the stilts on the breadboard so that the stage will mount
Line 59: Line 59:
   * 2 - M6 x 14 mm flat head screws on the recessed side   * 2 - M6 x 14 mm flat head screws on the recessed side
  
-[{{ ::​ftp-xystage-mount.png?​300 |//Figure 4: stage mounted using criss-cross pattern\\ (red arrows indicate 16 mm screws,\\ orange arrows indicate 14 mm screws)//​}}]+[{{ ::​ftp-xystage-mount.png?​400 |//Figure 4: stage mounted using criss-cross pattern\\ (red arrows indicate 16 mm screws,\\ orange arrows indicate 14 mm screws)//​}}]
  
 <WRAP center round info 60%> <WRAP center round info 60%>
Line 68: Line 68:
  
 3. After the screws are tightened, it is important to: 3. After the screws are tightened, it is important to:
 +  - Check that the screw tops are flush with or slightly below the surface of the stage bottom plate. If any protrude (i.e. are "​sitting proud"​) then the screw head is larger than it should be and moving the stage may scratch the middle plate. ​ Please contact ASI for new screws.
   - Check that the stage is level with the table; remove or loosen the screws if realignment is necessary.   - Check that the stage is level with the table; remove or loosen the screws if realignment is necessary.
   - Verify both stilts are plugged in.    - Verify both stilts are plugged in. 
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
ftp_setup.1555630449.txt.gz · Last modified: 2019/04/18 23:34 by 127.0.0.1