User Tools

Site Tools


inserting_pipette_into_pipette_holder

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
inserting_pipette_into_pipette_holder [2016/10/04 22:13]
127.0.0.1 external edit
inserting_pipette_into_pipette_holder [2019/04/18 23:34] (current)
Line 1: Line 1:
 +====== Inserting Pipette into Pipette Holder ======
  
 +1) Disassemble the O-ring compression subassembly from the pipette support subassembly.
 +
 +2) Insert the pipette through the support subassembly,​ and through the O-ring.
 +
 +3) Lightly tighten the outside nut to clamp the pipette without crushing it.
 +
 +4) Begin screwing the O-ring compression subassembly into the pipette support subassembly. ​ See the two figures below showing the uncompressed O-ring.
 +
 +[{{ pipette1.png?​direct&​300 |O-ring Uncompressed}}]
 +
 +[{{ pipette2.png?​direct&​150 |O-ring Uncompressed}}]
 +
 +5) Gently tighten the assembly until the O-ring is compressed around the pipette shaft. Be careful not to over-tighten. ​ See the two figures below.
 +
 +[{{ pipette3.png?​direct&​300 |Compressed O-ring}}]
 +
 +[{{ pipette4.png?​direct&​150 |Compressed O-ring}}]
 +
 +{{tag>​mppi tech_note}}
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
inserting_pipette_into_pipette_holder.txt · Last modified: 2019/04/18 23:34 (external edit)