User Tools

Site Tools


leica_leitz_laborlux_s_zdrive_install

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
leica_leitz_laborlux_s_zdrive_install [2016/11/04 17:16]
vik
leica_leitz_laborlux_s_zdrive_install [2016/11/04 17:16] (current)
vik
Line 39: Line 39:
  
 a) Locate the two parts baseplate and adjustment bar and connect them using two M4 x 10mm Low Head Socket Cap screws as seen in figure 2a. a) Locate the two parts baseplate and adjustment bar and connect them using two M4 x 10mm Low Head Socket Cap screws as seen in figure 2a.
 +
 b) Place the baseplate assembly and put it on the back of the microscope as show in 2b. b) Place the baseplate assembly and put it on the back of the microscope as show in 2b.
    
Line 46: Line 47:
              ​   ​              ​   ​
 c) Using a 1.5mm Allen wrench lightly tighten the adjustment bar set screw so that it holds onto the microscope but can still be moved around to adjust position for proper alignment. ​ c) Using a 1.5mm Allen wrench lightly tighten the adjustment bar set screw so that it holds onto the microscope but can still be moved around to adjust position for proper alignment. ​
 +
 d) Slightly loosen two baseplate screws to allow for aligning Z-Drive unit. d) Slightly loosen two baseplate screws to allow for aligning Z-Drive unit.
  
leica_leitz_laborlux_s_zdrive_install.txt ยท Last modified: 2016/11/04 17:16 by vik