User Tools

Site Tools


nikon_diaphot_200_300_te200_te300_zdrive_install

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
nikon_diaphot_200_300_te200_te300_zdrive_install [2016/11/03 11:14]
vik
nikon_diaphot_200_300_te200_te300_zdrive_install [2016/11/03 11:19] (current)
vik
Line 25: Line 25:
 [{{ diaphot200_2.png?​direct&​300 |Figure 2}}]    [{{ diaphot200_2.png?​direct&​300 |Figure 2}}]   
  
-Locate the cover and install it on the drive as shown using the Allen wrench and the supplied screws that are in the drive plate. ​ Before tightening the screws make sure the cover is positioned so that it does not rub against the outer clamp as shown. ​ Once the cover has been installed the original knob can be installed onto the protruding shaft. ​ Note that the slots on the shaft mate with the plastic tabs on the knob. +
- +
- +
- +
- +
                 
 Pull off the rubber boot from the end of the left fine focus knob to expose the nut shown in figure 1. Use screwdriver to remove this nut. Pull knob straight off to expose brass adapter plate as shown in figure 2. Pull off the rubber boot from the end of the left fine focus knob to expose the nut shown in figure 1. Use screwdriver to remove this nut. Pull knob straight off to expose brass adapter plate as shown in figure 2.
nikon_diaphot_200_300_te200_te300_zdrive_install.txt · Last modified: 2016/11/03 11:19 by vik