User Tools

Site Tools


nikon_fn1_flex_zdrive_install

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
nikon_fn1_flex_zdrive_install [2016/12/14 16:31]
vik [Part-3 Installing & Aligning the Motor Drive]
nikon_fn1_flex_zdrive_install [2016/12/15 10:01] (current)
vik
Line 2: Line 2:
  
 <WRAP center round info 60%> <WRAP center round info 60%>
-This is the manual for the new Flex coupler version of the Z drive. ​+This is the manual for the new Flex coupler version of the Z drive. ​This version was introduced in December 2016. If your kit has the Flex Coupler. Then this is the correct manual. If not, then refer to the [[nikon_fn1_zdrive_install|old FN1 manual]]. 
 + 
 +[{{::​flex_fn1_zdrive_install_03.jpg?​200|Flex Coupler}}] 
 + 
 </​WRAP>​ </​WRAP>​
  
Line 39: Line 42:
 [{{ ::​flex_fn1_zdrive_install_01.jpg?​500 |Figure 4b: Install baseplate}}] [{{ ::​flex_fn1_zdrive_install_01.jpg?​500 |Figure 4b: Install baseplate}}]
  
-Locate the ASI drive and baseplate assembly. ​ If the drive is attached to the base plate use the Allen wrench provided to remove the horizontal adjustment screw to remove the drive. ​ Install the baseplate as outlined in figures 4a – 4b above. Make sure it's square. Align the drive and base plate as shown so that the baseplate ​ is “about” ​parallel ​with the table. ​ Use the 1.5mm Allen wrench to tighten the base plate clamp as shown. ​+Locate the ASI drive and baseplate assembly. ​ If the drive is attached to the base plate use the Allen wrench provided to remove the horizontal adjustment screw to remove the drive. ​ Install the baseplate as outlined in figures 4a – 4b above. Align the drive and base plate as shown so that the baseplate ​ is “about” ​perpendicular ​with the table. ​ Use the 1.5mm Allen wrench to tighten the base plate clamp as shown. ​
  
 ===== Part-3 Installing & Aligning the Motor Drive ===== ===== Part-3 Installing & Aligning the Motor Drive =====
nikon_fn1_flex_zdrive_install.txt · Last modified: 2016/12/15 10:01 by vik