User Tools

Site Tools


nikon_te_200_300_diaphot

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
nikon_te_200_300_diaphot [2016/05/20 09:07]
vik
nikon_te_200_300_diaphot [2016/10/04 15:13] (current)
Line 55: Line 55:
 i) Recheck the alignment by noting the drag while rotating the right fine focus knob.  No noticeable drag should be felt.  If any drag is felt other than the slight drag of the gears, loosen the vertical and horizontal adjustment screws with the 7/64” hex wrench and move the drive around to a point where no drag is felt.  Then tighten the vertical and horizontal adjustment screws. ​ **Note: ​ there should be no point throughout the entire 360º rotation of the fine focus knob where an increase in drag is felt.  If drag is felt, repeat the above steps.** i) Recheck the alignment by noting the drag while rotating the right fine focus knob.  No noticeable drag should be felt.  If any drag is felt other than the slight drag of the gears, loosen the vertical and horizontal adjustment screws with the 7/64” hex wrench and move the drive around to a point where no drag is felt.  Then tighten the vertical and horizontal adjustment screws. ​ **Note: ​ there should be no point throughout the entire 360º rotation of the fine focus knob where an increase in drag is felt.  If drag is felt, repeat the above steps.**
  
-{{ :​documentation:​diaphot_200_zdrive.png?​direct&​300 |}}+{{ diaphot_200_zdrive.png?​direct&​300 |}}
    
  
nikon_te_200_300_diaphot.txt · Last modified: 2016/10/04 15:13 (external edit)