User Tools

Site Tools


oly_ix70_zdrive_installation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
oly_ix70_zdrive_installation [2016/03/30 15:07]
vik created
oly_ix70_zdrive_installation [2016/10/04 15:13] (current)
Line 46: Line 46:
 5.) Once the drive has been attached to the adjustment bar the clamp and clutch should be secured. While holding the right fine focus knob push the clamp on the ASI focus shaft in towards the microscope so that the brass clutch plate is firmly pressed up against the silver spring washer locate on the microscope’s brass assembly. Use the 7/64 inch hex wrench to securely tighten the clamp. ​ **Note: ​ The Clamp Must Be Securely Tightened Or The Drive And Clutch May Slip.** 5.) Once the drive has been attached to the adjustment bar the clamp and clutch should be secured. While holding the right fine focus knob push the clamp on the ASI focus shaft in towards the microscope so that the brass clutch plate is firmly pressed up against the silver spring washer locate on the microscope’s brass assembly. Use the 7/64 inch hex wrench to securely tighten the clamp. ​ **Note: ​ The Clamp Must Be Securely Tightened Or The Drive And Clutch May Slip.**
   
-[{{ :​documentation:​ix70_2_.jpg?​direct&​300 |Figure 1. ASI drive Installed}}] ​                                          ​  ​   ​+[{{ ix70_2_.jpg?​direct&​300 |Figure 1. ASI drive Installed}}] ​                                          ​  ​   ​
   
-[{{ :​documentation:​ix70_4_.jpg?​direct&​300 |Figure 2a. Adjustment bars, Horizontal Adj Screw }}]+[{{ ix70_4_.jpg?​direct&​300 |Figure 2a. Adjustment bars, Horizontal Adj Screw }}]
  
-[{{ :​documentation:​ix70_3_.jpg?​direct&​300 |Figure 2b. Adjustment bars, Vertical Adj Screws}}] +[{{ ix70_3_.jpg?​direct&​300 |Figure 2b. Adjustment bars, Vertical Adj Screws}}]
  
-[{{ :​documentation:​ix70_1_.jpg?​direct&​300 |Figure 3. Brass Clutch plate}}] +[{{ ix70_1_.jpg?​direct&​300 |Figure 3. Brass Clutch plate}}]
  
-[{{ :​documentation:​ix70_5_.jpg?​direct&​300 |Figure 4. Base plate clamp assembly}}]+[{{ ix70_5_.jpg?​direct&​300 |Figure 4. Base plate clamp assembly}}]
  
 6.) Slide the motor drive up and down, forward and backward slightly while turning the right fine focus knob until it is in the position where minimum drag is felt on the right focus knob.  Secure the motor drive into position by tightening the horizontal and vertical adjustment screws. 6.) Slide the motor drive up and down, forward and backward slightly while turning the right fine focus knob until it is in the position where minimum drag is felt on the right focus knob.  Secure the motor drive into position by tightening the horizontal and vertical adjustment screws.
oly_ix70_zdrive_installation.txt · Last modified: 2016/10/04 15:13 (external edit)