User Tools

Site Tools


optical_and_mechanical_alignment_on_ramm

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
optical_and_mechanical_alignment_on_ramm [2017/08/26 00:34]
vik [Aligning the Multi-LED Illuminator]
optical_and_mechanical_alignment_on_ramm [2018/05/23 20:17] (current)
vik [Setting the Automated Objective Turret and/or Automated Cube Slider Zero Position]
Line 84: Line 84:
 Use the same procedure for the automated filter cube slider. ​ Turn off the controller and manually slide the cube slider to the 1st position. ​ There is a white engraved mark on the slide that should be lined up with the side of the cube housing to accurately position the slider correctly. ​ Turn back on the controller and again, issue a [[commands:​reset|RESET command]] to the card controlling the slider.  ​ Use the same procedure for the automated filter cube slider. ​ Turn off the controller and manually slide the cube slider to the 1st position. ​ There is a white engraved mark on the slide that should be lined up with the side of the cube housing to accurately position the slider correctly. ​ Turn back on the controller and again, issue a [[commands:​reset|RESET command]] to the card controlling the slider.  ​
  
-''​TodoNeed picture of slider in correct position with the white line showing.''​+[{{ ::​slider_line2.jpg?​direct&​300 | Index line marked }}]
  
  
optical_and_mechanical_alignment_on_ramm.txt ยท Last modified: 2018/05/23 20:17 by vik