Controllers with the SLAVE_F_TO_Z module facilitates use of a master/slave set of motorized axes. When the master axis is moved or adjusted then the slave axis is correspondingly changed automatically. The user should almost always interact with the master axis so that the two axes remain synchronized. During setup it may be helpful to interact with the slave axis to get them mechanically aligned.
For these commands, moves or changes to the master axis will be applied to the slave axis automatically but not vice versa. It is possible to change only the slave axis by sending commands to it.
For these commands, changes made to either axis will be copied to the other one.
HALT= / because all axes are affected
ZERO BUTTONbecause all axes are affected
HOMEbutton because all axes are affected
PEDALactions are supported.
Make note that these following commands are not supported: