User Tools

Site Tools


tggalvo

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
tggalvo [2019/03/15 16:45]
vik
tggalvo [2019/03/19 12:21] (current)
vik
Line 1: Line 1:
 ====== TGGALVO / 4 Channel DAC card ====== ====== TGGALVO / 4 Channel DAC card ======
  
 +<WRAP center round important 60%>
 +CAUTION! On startup the card outputs will swing to -10Volts briefly. This may damage instruments that aren't designed to handle negative input. ​
 +</​WRAP>​
  
 TGGALVO card is a variant of the MicroMirror card(TGMM4) capable of running the same(or other) firmware. Instead of the MEMS drive electronics,​ it buffers, amplifies and outputs the DAC signals. ​ TGGALVO card is a variant of the MicroMirror card(TGMM4) capable of running the same(or other) firmware. Instead of the MEMS drive electronics,​ it buffers, amplifies and outputs the DAC signals. ​
Line 10: Line 13:
   * TGGALVO has four 12 bit DAC onboard. ​   * TGGALVO has four 12 bit DAC onboard. ​
   * Has TTL pins connected to TG-1000'​s backplane, so it can sync with other cards in the TG-1000 controller? ​   * Has TTL pins connected to TG-1000'​s backplane, so it can sync with other cards in the TG-1000 controller? ​
-  * Multiple DAC output voltage modes are available. Like 0V to 2V, 0V to 4V, 0V to 10V, -1V to 1V, -2V to 2V, -5V to 5V and -10V to 10V(default). Set with the [[commands:​pm|PM command]]+  * Multiple DAC output voltage modes are available. Like 0V to 2.048V, 0V to 4.096V, 0V to 10.24V, -1.024V ​to 1.024V, -2.048V ​to 2.048V, -5.128V ​to 5.128V ​and -10.24V ​to 10.24V(default). Set with the [[commands:​pm|PM command]]
   * Can output a maximum of 10ma per channel. ​   * Can output a maximum of 10ma per channel. ​
   * 100 ohm resistor in series at BNC output   * 100 ohm resistor in series at BNC output
Line 16: Line 19:
   * Can be configured to drive a Galvo amplifier, Piezo amplifier and other devices that can accept an analog voltage input. ​   * Can be configured to drive a Galvo amplifier, Piezo amplifier and other devices that can accept an analog voltage input. ​
   * Compatible with Micro-Manager and diSPIM plugin. ​   * Compatible with Micro-Manager and diSPIM plugin. ​
 +
 +
 +
 +
  
 {{tag>​manual tiger micromirror galvo dac piezo}} {{tag>​manual tiger micromirror galvo dac piezo}}
tggalvo.1552693503.txt.gz ยท Last modified: 2019/03/15 16:45 by vik