av200_flattop_installation
Differences
This shows you the differences between two versions of the page.
Previous revision | |||
— | av200_flattop_installation [2021/09/23 17:15] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== AV200 Flat Top Stage Installation ====== | ||
+ | |||
+ | {{ av200_flattop_2_.jpg? | ||
+ | |||
+ | Remove System from packaging. | ||
+ | |||
+ | {{ av200_flattop_3_.jpg? | ||
+ | |||
+ | The stage will be shipped in the center position allowing you to install the rear mounting screw located at the back of the stage in the center position. | ||
+ | |||
+ | <WRAP center round important 60%> | ||
+ | DO NOT force the stage by hand to achieve the three distinct mounting positions. | ||
+ | </ | ||
+ | |||
+ | |||
+ | {{ av200_flattop_4_.jpg? | ||
+ | |||
+ | With the controller powered on move the stage, using the controller joystick, to the right until the plate cut out is aligned over the microscope mounting screw hole position. | ||
+ | |||
+ | {{ av200_flattop_1_.jpg? | ||
+ | |||
+ | Next move the stage, again with the controller joystick, to the left until the plate cut out is aligned over the microscope mounting screw hole position. | ||
+ | |||
+ | {{tag> | ||
Address: 29391 W Enid Rd. Eugene, OR 97402, USA | Phone: +1 (541) 461-8181
av200_flattop_installation.txt · Last modified: 2021/09/23 17:15 by 127.0.0.1